Make every degree count.
Position, torque and live feedback in one place.
Position control
IDLEZero at 9 o’clock · Counterclockwise is positive
Home saves the current position; Go to home returns to it.
No home position saved yet.
Original ZeroGui direction commands. Motor firmware endpoints still apply.
Waiting for data.
Pitch · torque
NO DATAZero torque at 9 o’clock, the wind vane direction · Needle swings counterclockwise for positive torque · Green band ±0.30 Nm
Automatic Pitch Control
Holds the shaft at zero torque so the vane faces the wind. Push the shaft and the motor moves with you instead of fighting; short gusts are ignored and the position locks after each correction.
Enable Auto to start the wind response model.
The three torque boxes must go up in this order: Zero zone < Anti-jitter sensitivity < Max torque.
Torque inside the Anti-jitter sensitivity band never moves the motor. RPM max waits for an RPM sensor.
Nudge with the dial while Auto stays active.
Simulation inputs
MODELTorque responds as the simulated motor turns.
Drive extensions
UNAVAILABLEControls appear when a verified motor command is available.
Live camera
OFFChoose the laptop’s USB camera
and share it with signed-in viewers.
Start selected camera to share video from the laptop. No audio.
Motor
KOLLMORGEN- Continuous torque
- 6.11 Nm
- Peak torque
- 18.0 Nm
- Drive limit in use
- ±5 Nm · 82 % of continuous
- Load now
- —
- Case temperature
- —
Connection
HOST LAPTOP- Source
- —
- Motor model
- Kollmorgen KBM-43S01-C0
- Controller
- —
- Control access
- —
- Last update
- —
Desktop mode shares the laptop’s motor connection. Select Simulation on the host laptop to explore the controls independently.
Installer downloads
SETUPNetZeroGo Suite installers built on the host laptop. Install on a control PC, not on the running demo laptop.
| Time | Source / event | Packet or message |
|---|
Events will appear here as the application runs.
Protocol reference only. Catalog rows do not send motor commands.
| ID | Command | Meaning | Evidence |
|---|
See the storm before it arrives.
Live National Weather Service forecast, alerts and Storm Prediction Center outlooks for the turbine’s GPS position.
Live wind · Sherman, TX
—- Station
- —
- Observed
- —
- NWS forecast · this hour
- —
Catastrophic weather tilt
TOWER UPThe rotor brake and hydraulic tilt are simulated until that hardware is installed. The Automatic Pitch Control and yaw-park steps command the real motor.
Protection rules
Storm scope
LIVE NWSWarning areas from the National Weather Service appear here when they are issued for the region.
Protection log
Live NWS radar — KFWS
LOOPThe radar loop loads when this page is open.
NWS RIDGE radar loop from radar.weather.gov, reloaded every 5 minutes.
Open the interactive NWS radar ↗GPS position
DEMO FIX- Source
- Fixed demo coordinates · GPS receiver not connected
- NWS office · grid
- —
- County · zone
- —
- Radar · station
- —
Change location
A GPS receiver on the turbine will set this automatically.
Right now
—- Conditions
- —
- Temperature
- —
- Humidity · dew point
- —
- Pressure
- —
- Visibility
- —
- Observed
- —
7-day wind outlook
Today
—| Time | Wind | Gust | Dir | Temp | Rain | Thunder | Forecast |
|---|
Watches & warnings
0 ACTIVEStorm Prediction Center outlook at the site
| Day | Risk | Tornado | Wind | Hail / any severe |
|---|
Forecast, observations and alerts: NOAA National Weather Service. Severe weather outlooks: NOAA Storm Prediction Center. Hub-height wind is an estimate from the 10 m forecast (1/7 power law).
